Measure from the flat edge of the female end to the matching flat edge of the male end. * Do not measure to the end of the teeth on the male end, this will give you too large of a measurement. Please reference where the two pencils are pointing to in the photo below.

Measure from the fold of the belt to the hole you use on your dog. Please reference where the two pencils are pointing to in the photo below.

It’s easier to take the measurement at the back of the neck. Place the tape around the neck snuggly, not tight. Your measurement is where the end of the tape meets the number on the tape.

Measurement should be taken at the mid section of the neck.

Each of our collars are designed for one dog, your dog. We make your dog’s collar to the size you specify, with a 3/4” tolerance (wiggle room), which means there are 3 holes:

• 3/4” smaller than your dog’s neck size
• Your dog’s neck size
• 3/4” bigger than your dog’s neck size

*Your dog’s collar will be fit to buckle in the middle hole.